Toyota 4Runner 3rd Gen K9 Roof Rack Kit

The Eezi-Awn K9 Roof Rack is a modern take on the expedition platform: thinner, lighter, quieter, and more aerodynamic than the cage racks it replaces, and built to carry a rooftop tent, awning, and a full load of recovery gear across the continent. This kit is cut specifically for the 3rd Gen Toyota 4Runner and bolts on with no drilling.

Key Features

• Vehicle-specific, no-drill fit: The proprietary mounting rail sits over the roof pinch-weld trim and uses the OEM roof rack mounting points, so nothing gets drilled. It replaces the factory rack and leaves the sunroof fully uncovered.
• Sizes for your build: Offered in a 1250mm (49") width and two lengths. The most popular 1.6M (62") starts a few inches behind the sunroof and finishes just in front of the rear hatch.
• Standard-height stance: A 5" overall height on 65mm feet leaves room to run accessories on the underside of the platform.
• Serious capacity: On a suitably suspended vehicle, dynamic loads around 500 lb and static loads up to 1000 lb are achievable. These figures are not warrantied and your capacity will vary.
• Accessory ecosystem: Bolt-on jerry can holders, axe and shovel mounts, Hi-Lift and MaxTrax mounts, awning mounts, and under-rack table mounts all attach directly to the platform.
• Thule & Yakima compatible: Store-accessible 6mm hardware lets you attach existing Thule or Yakima sport-bar mounts (Thule Podium Foot Pack 460 with Fit Kit KIT3101; Yakima Skyline Tower with Landing Pad 4) to the K9 perimeter for bikes, kayaks, and more.

Specifications

Fitment

Cut specifically for the 3rd Gen Toyota 4Runner (1996–2002). The mounting rail uses the OEM roof rack points, so no drilling is required.

Browse the full range of Eezi-Awn K9 roof racks, and load yours out with mounts and holders from our roof rack accessories.

Ships LTL freight, contiguous U.S.